Table of Contents
Advertisement
22 Small form factor pluggable transceivers
The following table lists and describes the supported Nortel SFP models
with DDI capability. All the optical SFPs use LC connectors.
SFP models with DDI capability
Model number and connector
1000BASE-T (RJ-45)
1000BASE-BX
1000BASE-LX
For specifications, see
Installing an SFP
Install an SFP to provide an interface between the switch and the network
cable.
Installing an SFP takes about three minutes.
For translations of the following statements, see
caution messages" (page 14)
Copyright © 2007, Nortel Networks
.
Product number
AA1419043-E6
AA1419069-E6,
AA1419070-E6
AA1419074-E6
"SFP specifications" (page
and
WARNING
Risk of eye injury by laser
Fiber optic equipment can emit laser or infrared light that can
injure your eyes. Never look into an optical fiber or connector port.
Always assume that fiber optic cables are connected to a light
source.
CAUTION
Risk of equipment damage
To prevent damage from electrostatic discharge, always wear an
antistatic wrist strap connected to an ESD jack.
CAUTION
Risk of equipment damage
Only trained personnel can install this product.
Ethernet Routing Switch 4500 Series
Installation — SFPs and XFPs
NN47205-301 (324186-A) 01.04 Standard
5.1 6 December 2007
Description
CAT5 UTP, up to 100 m. Note that
because the 1000BASE-T device is
all electrical, there is no need for DDI
support.
Bidirectional 1310 nm and 1490 nm, up
to 10 km, DDI
1310 nm, up to 10 km, DDI
33).
"ESD and installation
"Laser safety warnings" (page
16).
Advertisement
Table of Contents
