Troubleshooting - Echo Pro Attachment Series Operator's Manual

TROUBLE SHOOTING
TROUBLE SHOOTING
Problem
The machine No electrical contact
does not between the machine
start when and the battery.
you push
The battery is depleted. Charge the battery.
the power
switch.
The lock-off lever switch
and power switch are
not pushed at the same
time.
The machine The battery or machine
stops when is too hot.
you cut.
The battery is
disconnected from the
tool.
The battery is depleted. Charge the battery.
Red Charger Plug not connected to
light flashes power outlet.
or does not
Battery pack not
light up.
installed properly.
Obstructed connection. Reinstall battery after removing
Fault in the charger.
Fault in the battery
pack.
Unit will not Battery pack not
turn on installed properly.
Unit does Battery pack
not run when discharged.
turned on
Battery pack outside
acceptable temperature
range.
Running time Battery pack outside
is too short. acceptable temperature
range.
Unit electronics too hot. Turn unit off and allow to cool.
Battery pack
discharged.
48
Possible Cause Solution
1. Remove battery.
2. Check contact and install the battery
again.
1. Push the lock-off lever switch and
hold it.
2. Pull the power switch to start the
machine.
1. Cool the battery until its func-tion
returns to normal.
2. Cool the machine for approximately
10 minutes.
Install the battery again.
Plug in charger.
Check the battery installation.
obstructions.
Consult your dealer.
Consult your dealer.
Check battery installation.
Charge battery.
Remove the battery and allow to cool.
Remove battery and allow to cool.
Charge the battery.
© 12/2022 ECHO Incorporated
DPAS-2100
99922238047