Nokia N93i User Manual page 117

WLAN security sett. — Enter the settings for the selected
security mode:
Security settings for WEP are as follows:
Wep key in use — Select the WEP key number. You can
create up to four WEP keys. The same settings must be
entered on the wireless LAN access point device.
Authentication type — Select
authentication type between your device and the wireless
LAN access point device.
WEP key settings — Enter WEP encryption
key), WEP key format (ASCII
key (the WEP key data in the selected format).
Security settings for 802.1x
follows:
WPA mode — Select the means of authentication:
use an extensible authentication protocol (EAP) plug-in or
Pre-shared key to use a password. Complete the
appropriate settings:
EAP plug-in settings (only for EAP) — Enter the settings
as your service provider instructs.
Pre-shared key (only for Pre-shared
password. The same password must be entered on the
wireless LAN access point device.
Open or Shared for the
(length of the
or Hexadecimal), and WEP
and WPA/WPA2 are as
EAP to
key) — Enter a
TKIP encryption — Select whether Temporal Key Integrity
Protocol (TKIP) is used.
Homepage — Define a home page.
Select Options > Advanced settings
following:
IPv4 settings: Phone IP address
device), Subnet mask (the subnet IP address),
gateway (the gateway), and
addresses of the primary and secondary DNS server.
Contact your internet service provider for these addresses.
IPv6 settings > DNS address
Well-known, or User defined.
Ad-hoc channel (only for Ad-hoc) — To enter a channel
number (1-11) manually, select
Proxy serv. address — Enter the address for the proxy
server.
Proxy port number — Enter the proxy port number.
Packet data
The packet data settings affect all access points using a
packet data connection.
Packet data conn. — If you select
you are in a network that supports packet data, the device
registers to the packet data network. Starting an active
Copyright © 2007 Nokia. All rights reserved.
and from the
(the IP address of your
Default
DNS address — Enter the IP
— Select Automatic,
User defined.
When available and
107