Summer Operation; After Finishing Work; Preparing For Transportation Or Storage - Stihl FS 361 C-M Owner's Instruction Manual

16 After Finishing Work

1
2
► Remove the screw (1).
► Pull out the shutter (2).
► Re-insert the shutter as shown above. The "winter"
symbol points toward the mark (3).
► Push the shutter into the slot until it stops.
► Tighten the screw.
NOTICE
The winter operation setting should only be used in ambient
temperatures below 50 °F (10 °C). Use at higher
temperatures may cause the engine to overheat, resulting in
permanent damage. Always remember to return the shutter
to the configuration that is appropriate for ambient
temperature conditions.
In extreme wintry conditions with temperatures below
+ 14 °F (- 10 °C) or when working in powder or drifting snow,
a cover plate must also be mounted to the engine housing
and an air filter with plastic mesh must be installed. These
accessories are available from STIHL servicing dealers.

15.4 Summer Operation

The shutter must be set to summer mode when working at
temperatures above 50 °F (10°C).
► Shut off the engine, @ 12.1.
0458-838-8601-A
1
2
3
1
2
► Remove the screw (1).
► Pull out the shutter (2).
► Re-insert the shutter as shown above. The "summer"
symbol points toward the mark (3).
► Push the shutter into the slot until it stops.
► Tighten the screw.
16 After Finishing Work

16.1 Preparing for Transportation or Storage

WARNING
To reduce the risk of personal injury from unintended
activation or unauthorized use, shut off the engine and
ensure the cutting attachment has stopped before
transporting the trimmer or putting it down.
To prepare the trimmer for transportation or storage:
► Shut off the engine, @ 12.1.
► If using a metal cutting attachment, mount the transport
guard.
► Wait for the engine to cool down.
English
1
2
3
39