Putting On The Harness - Stihl MSA 161 T Instruction Manual

English
of the operator's body, where the chain saw is held and
controlled. Do not allow the connecting cord to swing across
your body or hang at your side.
C
The length of the connecting cord can be adjusted by
making a loop around the top (Illustration C) or on the side
(Illustration D) of the backpack battery with the hook and eye
fasteners.
► Position and secure the connecting cord so that it will not
interfere with proper working technique or your ability to
maintain control of the chain saw.

13.3 Putting on the Harness

WARNING
The operator must be able to remove the backpack battery
quickly in the event of an emergency. In an emergency,
open and remove the waist belt and chest strap quickly
before dropping the battery to the ground.
34
D
To ensure a proper fit:
► Put the backpack battery on your back.
► Fasten and adjust the waist belt (2) so that it rests
comfortably but securely on your hips.
► Fasten the chest strap (1) and adjust it so that it fits
comfortably but securely across your chest.
► Adjust the harness straps so that the back padding fits
snugly and securely against your back.
► Always wear the battery harness over both shoulders.
► Thread the end of the waist belt through the loops (3)
and (4).
► To remove the harness, open the quick-release fasteners
on the waist belt and chest strap and loosen the harness
straps by lifting the sliding adjusters.
13 STIHL AR L Backpack Battery
1
3
4
0458-791-8221-C