Display Configuration; Call Configuration; Connection Configuration; Access Points - Nokia E62 User Manual

S e t t i n g s
Navigation key right, Navigation key
•
open when you scroll to different directions. These settings are not available if you select

Display configuration

Select Display and from the following:
Light sensor — Adjust the amount of light required to illuminate the device display.
•
Power saver time-out — Select the amount of time before the screen saver is activated. Activating the screen saver lengthens
•
the device operating time.
Light time-out — Set how quickly after last keypress the display dims.
•

Call configuration

Select Call and from the following:
Send my caller ID — Select
•
determine whether your caller ID is sent.
Call waiting — Select Activate
•
if the function is active on the network.
Reject call with SMS — Select
•
cannot answer their incoming call.
Message text — Enter the text that is sent when you cannot answer an incoming call and want to automatically send a text
•
message as a reply.
Automatic redial — Select
•
attempts to connect the call.
Summary after call — Select
•
1-touch dialing — Select
•
keys (2-9), press and hold the key.
See "1-touch dial," p. 23.
Anykey answer — Select
•
Line in use — Select Line 1
•
setting is displayed only if the SmartChip supports the alternate line service and a subscription to two phone lines.
Line change — Select Disable
•

Connection configuration

Select Menu Settings
> >

Access points

— Set up new or edit existing access points. Some or all access points may be preset for your device by your
•
service provider, and you may not be able to create, edit, or remove them.

Access point groups

— Set up new or edit existing access point groups that are used in automatic connection establishment
•
and e-mail roaming.
Packet data — Determine when packet data connections are used, and enter the access point if you use your device as a
•
modem for a computer.
SIP settings — View or create session initiation protocol (SIP) profiles.
•
Data call — Set the time-out period after which data call connections automatically end.
•
VPN — Install and manage VPN policies, manage VPN policy servers, view the VPN log, and create and manage VPN access
•
points.
Configs. — View and delete trusted servers from which your device may receive configuration settings.
•
To obtain information about subscribing to a packet data service and the appropriate connection and configuration settings,
contact your network operator or service provider.
The settings available for editing may vary.
Access points
Select Menu Settings
> >
Some or all access points may be preset for your device by your service provider, and you may not be able to create, edit, or
remove them.
See "Internet access points," p. 67.
Access point groups
Select Menu Settings
> >
An access point group is used for grouping and prioritizing access points. An application can use a group as a connection method
instead of a single access point. The best available access point inside a group is used for making a connection.
Copyright © 2006 Nokia. All Rights Reserved.
left, Navigat. key
Yes to display your phone number to the person you are calling or
to be notified of a new incoming call while you have a call in progress or
Yes to send a text message automatically to the person who is calling you informing why you
On to redial a number if it was busy at the first call attempt. Your device makes a maximum of 10
On to briefly display the approximate duration of the last call.
On to activate speed dialing on your device. To dial a phone number assigned to the speed dialing
On to answer an incoming call by briefly pressing any key, except the end key.
or Line 2 to change the phone line for outgoing calls and text messages (network service). This
to prevent line selection (network service). To change this setting, you need the PIN2 code.
Config. Connection and from the following settings:
>
Config. Connection Access
> >
Config. Connection Access point
> >
down, Navigation key up,
points.
groups.
30
Selection key — Change the shortcuts that
Active idle > On.
Set by network
Check status
to let the network
to check