Preparation; Control Elements; Fitting And Removing The Auxiliary Handle; Changing The Band Saw Blade - Parkside PMBA 20-Li A1 Translation Of The Original Instructions

GB
operation. Under certain circumstances, this
field may negatively affect active or pass-
ive medical implants. In order to reduce the
danger of serious or fatal injuries, we recom-
mend that individuals who wear medical im-
plants should consult their doctor and the man-
ufacturer of the implant before operating the
machine.

Preparation

WARNING! Risk of injury due to uninten-
tional start-up. Only insert the rechargeable
battery into the device once the device is fully
prepared for use.

Control elements

Familiarise yourself with the operating elements
before using the device for the first time.
• Switch lock (3)
• Unlocking: Press
• Locking: Release
• On/Off switch (4)
• Switching on: Press
• Switching off: Release
• Rotary wheel (2)
Set the rotational speed in 6 increments.
Fitting and removing the
auxiliary handle
WARNING! Loss of control can result in
injuries! Never operate the device hands-free
without the auxiliary handle.
Mounting the auxiliary handle
You can attach the auxiliary handle to the right
and left of the device.
1. Turn the auxiliary handle (1) firmly into one
of the two mountings.
Removing the auxiliary handle
1. Turn the auxiliary handle (1) out of the
mounting.
24
Changing the band saw
blade
Notes
• Only use saw blades recommended by the
manufacturer with the following dimensions:
733,0 mm × 12,7 mm × 0,4 mm
Tools required
• Allen key (11)
Removing the band saw blade (Fig. A)
WARNING! Cutting injuries! Wear cut-res-
istant gloves when working with the saw blade.
1. Remove the battery (14).
2. Loosen the hexagon socket screws (19) of
the cover (20).
3. Open the cover (20).
4. Turn the tension lever (9) ⭮ to the stop
(180°).
5. Remove the band saw blade (8). Begin with
the rollers (22).
Mounting the band saw blade (Fig. A)
WARNING! Cutting injuries! Wear cut-res-
istant gloves when working with the saw blade.
1. Insert the band saw blade (8) fully into the
guides (6).
2. Place the band saw blade (8) around the
rollers (22).
3. Make sure that the band saw blade (8)
rests in the guides (6) and on the support
roller (21).
4. Close the cover (20).
5. Secure the cover (20) with the hexagon
socket screws (19).
6. Turn the tension lever (9) ⭯ to the stop
(180°).
7. Check the band saw blade (8) for correct
fit. To do this, switch the device on and off
briefly several times.
Checking the charge status of
the battery
1.
Press the charge level indicator but-
ton (15) on the battery (14).
✔ The charge level of the battery is indic-
ated by illumination of the corresponding
LED lights.