EAW MKC Series Instructions Manual page 6

MKC Series
Locking washer is first on bolt, then flat washer, rubber washer to be inside of U-Bracket flanges
ii. The mounting point is always connected to the MKC Series Loudspeaker using the
M10 screw location on the top and bottom of the MKC Series Loudspeaker.
1. The outermost mounting point "A" is designed as an open slot to allow for easy
locatinog of an MKC Series loudspeaker and loosely pre-installed hardware when
using the slotted mounting point, the MKC Series U-Bracket must be installed
oriented with the slot angled upward, opposing the ground.
iii. Use of the angle lock point is optional. The angle lock point is used for locking the
MKC Series Loudspeaker at a specific set angle.
b. Installing the MKC Series Loudspeaker onto a mounted MKC Series U-Bracket.
i. WARNING: Take care when handling and wear PPE gloves to protect from crushing
and impacts with digits, limbs, and/or product.
ii. Note, for weather protected applications (using MKC-WP Series Loudspeakers), apply
user-supplied, waterproof, non-hardening, non-locking thread sealant to the threads of
two button head screws (B) & the single socket head screw (F) per the thread sealant's
instructions. Failure to do so could result in water ingress and damage to the loudspeaker.
iii. Onto each of two button head screws (B), place a split-lock washer (C) and a flat
washer (D).
iv. Onto each of the socket head screw (F), place a split-lock washer (H) and a flat washer
(G).
U-Bracket Instructions
Tel 800 992 5013 / +1 508 234 6158
|
www.eaw.com
6