EAW MKC Series Instructions Manual page 5

MKC Series
NOTE: the outermost mounting point "A" is designed as an open slot to allow for easy locating of an MKC
Series Loudspeaker and loosely pre-installed hardware. If using the slotted mounting point, the MKC
Series U-Bracket must be installed oriented with the slot angled upward as visually shown in Figure 1,
opposing the ground.
c. Level - The back flange of the MKC Series U-Bracket must be level when installed to the
mounting surface for either figure 1 or 2 orientation and before installing an MKC Series
Loudspeaker to the U-Bracket.d. Any geometric or structural modifications to the MKC
Series U-Bracket or hardware are not EAW-approved will void the warranty and may result
in damage, injury, or death.
d. Mounting options
NOTE: It is recommended that you consult a building professional for the proper mounting hardware
before mounting the bracket. Due to various construction methods and materials, the hardware for
securing the bracket to the mounting surface is not supplied. It is required that the use of hardware
locking methods, not limited to lock washers, thread-locker, or nylon-retention feature, be applied when
securing the u-bracket to the mounting surface or structure.
The MKC U-Bracket has multiple mounting hole options as shown above
i. One Ø5/8in (Ø15.9mm) hole.
1. This hole can be used as a ceiling pole mount or a wall wire pass through.
2. If installing the MKC Series U-Bracket by this hole, a secondary safety point is
suggested to be secured.
ii. Two inner Ø5/16in (Ø8.5mm) holes.
1. These inner holes are spaced apart from each other on center and aligned.
2. These two inner holes may be used to install the MKC Series U-Bracket to a
mounting surface using load bearing hardware; both holes must be secured.
4. Installation of an MKC Series Loudspeaker to the MKC Series U-Bracket.
a. Choosing an MKC Series Loudspeaker configuration
i. Each MKC Series U-Bracket has an angle lock option.
ii. The mounting point is always connected to the MKC Series Loudspeaker using the
M10 screw location on the top and bottom of the MKC Series Loudspeaker.
U-Bracket Instructions
Tel 800 992 5013 / +1 508 234 6158
|
www.eaw.com
5