The Print Heads Stop Moving; What To Do First; If The Print-Head Carriage Move To The Standby - Roland VersaSTUDIO User Manual

The Print Heads Stop Moving

If the print-head carriage stops over the platen, take action immediately to prevent the heads from drying
out.

What to Do First

Hold down the [POWER] key for one second or longer to switch the sub power off, then back on. If the
media is jammed, then also remove the media.
If the print-head carriage move to the standby position (on the right side of the machine), it means the
operation has ended successfully.
If The Heads Still Do Not Move
Try switching off the main power, then again switching on the main power, followed by the sub power.

If the print-head carriage move to the standby

If the heads still do not move after "What to Do First" is performed, carry out the following emergency
response measure, then contact your authorized Roland DG Corp. dealer.
Procedure
1.
Switch off the main power and open the front cover.
2.
Gently move the print heads to the standby position.
Stopping at the place where the audible click is heard locks the print heads in place.
99
Machine Problems