Memory Seats - Cadillac LYRIQ 2023 Owner's Manual

36 Seats and Restraints
The massage feature will turn off after
approximately 20 minutes. Press the center
of the control to restart the massage
feature.

Memory Seats

Overview
If equipped, the memory seat feature allows
drivers to save their unique driving positions
and a shared exit position. See Saving
Seating Positions later in this section. The
saved positions can be recalled manually by
all drivers. See Manually Recalling Seating
Positions later in this section. Drivers with
remote key 1 and 2 can also recall them
automatically. See Auto Seat Entry Memory
Recall or Auto Seat Exit Memory Recall
later in this section. To enable automatic
recalls, turn on Seat Entry Memory and/or
Seat Exit Memory. See Enabling Automatic
Recalls later in this section. The memory
recalls may be cancelled at any time during
the recall. See Cancel Memory Seating
Recalls later in this section.
Identifying Driver Number
The vehicle identifies the current driver by
their remote key number 1 8. The current
remote key number may be identified by
Driver Information Center (DIC) welcome
message, You are driver x for memory
recalls. This message is displayed the first
few times the vehicle is turned on when a
different remote key is used. For Seat Entry
Memory to work properly, save positions to
the 1 or 2 memory button matching the
driver number of this welcome message. To
aid in identifying remote key IDs, it is
recommended to only carry one remote key
when entering the vehicle. Perform the
following if the welcome message is not
displayed:
1. Move all remote keys away from the
vehicle.
2. Turn the vehicle on with another remote
key. A DIC welcome message should
display indicating the driver number of
the other remote key. Turn the vehicle
off and remove the other remote key
from the vehicle.
3. Turn the vehicle on with the initial
remote key. The DIC welcome message
should display the driver number of the
initial remote key.
Saving Seating Positions
Read these instructions completely before
saving memory positions.
To save preferred driving positions to
1 and 2:
1. Turn the vehicle on. A DIC welcome
message may indicate the driver number
of the current remote key. See
Identifying Driver Number previously in
this section.
2. Adjust all available memory features to
the desired driving position.
3. Press and release SET; a chime will
sound.
4. Immediately upon releasing SET, press
and hold memory button 1 or 2 matching
the current driver s remote key number
until two chimes sound. If too much
time passes between releasing SET and
pressing 1 or 2, the two chimes will not