Cadillac LYRIQ 2023 Owner's Manual page 105

Warning (Continued)
important when towing a trailer, which
puts additional stress on your vehicle s
braking system.
See Hill and Mountain Roads 0 163 for
important information about driving on
grades.
The default charge level is 100% when
plugged in. To set a different charge level,
drag the circular marker on the Target
Charge Level Gauge to the preferred value.
To lower the desired Charge Level, drag the
Charge Level marker counterclockwise, and
to increase it drag the marker clockwise. The
Charge Level can also be changed by
« ª
tapping and inside the gauge on the
screen. The multifunction controller (MFC)
on the center console can also be used to
set the Charge Level by rotating clockwise or
counterclockwise when the Target Charge
Level Gauge is highlighted. The Range
estimate updates once the desired Charge
Level is set. To optimize battery health, the
minimum allowable Charge Level is
determined by the vehicle.
Charge Later
Instead of charging immediately to a desired
Charge Level, you may choose to delay the
charge to the vehicle and have it complete
by your desired departure time. This may be
a more economical choice and a more
efficient use of energy when charging at
home. To use this mode, touch the Charge
Later tab from the Next Charge screen.
With Charge Later selected, the Charging
screen displays:
Text explaining that your vehicle will
delay the planned charge to be ready by
the time specified.
Time Selector: Used to set the desired
time at which the vehicle will finish
charging and be ready for departure.
Instruments and Controls
Target Charge Level Gauge: Sets
the percentage at which the vehicle will
stop charging. The gauge also displays an
estimate of the vehicle's range upon
completing the charging session.
Cabin Pre-Conditioning: Allows the vehicle
to heat or cool the cabin to your desired
temperature using energy from the
charger. This means energy from the
battery is not used to condition the cabin,
ensuring the vehicle gets the maximum
range from the charging session. Cabin
pre-conditioning happens at the end of
the charge, and right before the
departure time.
To set the time at which the vehicle will
complete the charge and be ready for
departure:
Swipe up or down on each value within the
Time Selector until the preferred time is
selected. The time selector can also be
modified using the multifunction controller
(MFC) on the center console by turning the
knob when the preferred value is
highlighted. If the desired Charge Level
cannot be reached by the selected time, a
message will display that one of the two
preferences will need to be adjusted.
103