Leaving The Operator's Seat; Mounting And Dismounting - Komatsu 860E-1KT Operation & Maintenance Manual

Safety - Section 20
Page 20-2

Leaving The Operator's Seat

When preparing to leave the operator's seat, do not
touch any control lever that is not locked. To prevent
accidental operations from occurring, always perform
the following:
• Move the directional control lever to PARK. Do not
use the wheel brake lock when the engine will
be turned off.
• Lower the dump body to the frame.
• Stop the engine. When exiting the truck, always
lock compartments and take the keys with you. If
the truck should suddenly move or move in an
unexpected way, this may result in serious bodily
injury or death.

Mounting And Dismounting

• Use the handrails and steps when getting on or off
the truck.
• Never jump on or off the truck. Never climb on or off
a truck while it is moving.
• When climbing on or off a truck, face the truck and
use the hand-hold and steps.
• Never hold any control levers when getting on or off
a truck.
• Always maintain three-point contact with the hand-
holds and steps to ensure that you support
yourself.
• When bringing tools
compartment, always pass them by hand or pull
them up by rope.
• If there is any oil, grease, or mud on the hand-holds
or steps, wipe them clean immediately. Always
keep these components clean. Repair any damage
and tighten any loose bolts.
into the operator's
Fire Prevention For Fuel And Oil
• Fuel, oil, and antifreeze can be ignited by a flame.
Fuel is extremely
hazardous. Keep flames away from flammable
fluids.
• Keep oil and fuel in a designated location and do
not allow unauthorized persons to enter.
• When refueling, stop the engine and do not smoke.
• Refueling and oiling should be done in well
ventilated areas.
• Tighten all fuel and oil tank caps securely.
8/11 OM2041
flammable and can be