Table of Contents
Advertisement
318 Breakdown assistance
Affix part
1
of the TIREFIT sticker to the
#
instrument cluster within the driver's field of
vision.
2
Affix part
of the TIREFIT sticker near the
#
valve on the wheel with the defective tire.
Pull plug
4
with the cable and hose
#
of the tire inflation compressor housing.
Push the plug of hose
#
1
sealant bottle
until the plug engages.
Place tire sealant bottle
#
into recess
2
of the tire inflation compressor.
Remove the valve cap from valve
#
faulty tire.
Screw filling hose
8
#
Insert plug
4
into a 12‑V‑socket in your vehi-
#
cle.
Switch on the vehicle.
#
5
out
5
into flange
6
of tire
Switch on the tire inflation compressor using
#
On/Off switch 3.
The tire is inflated. First, tire sealant is pum-
1
head downwards
ped into the tire. The pressure may briefly rise
to approximately 500 kPa (5.0 bar/73 psi).
Do not switch off the tire inflation compressor
during this phase!
Let the tire inflation compressor run for a max-
#
imum of ten minutes.
The tire should then have attained a tire pres-
sure of at least 200 kPa (2.0 bar/29 psi).
If tire sealant leaks out, make sure you clean the
affected area as quickly as possible. It is prefera-
ble to use clean water.
7
on the
If you get tire sealant on your clothing, have it
cleaned as soon as possible with perchloroethy-
onto valve 7.
lene.
If, after ten minutes, a tire pressure of 200 kPa
(2.0 bar/29 psi) has not been attained:
Switch off the tire inflation compressor.
#
Unscrew the filling hose from the valve of the
#
defective tire.
Advertisement
Table of Contents
