Table of Contents
Advertisement
A
The hardware installation procedure for the PICE system depends on the host development
system, the number of PICE chassis in the system, and the system options. Begin installation
of your PICE system using the installation instructions in this appendix. The appendix has
sections on the following host-independent topics.
•
Installing the PICE instrumentation chassis
•
Installing the emulation base module
•
Installing personality modules and user cables
•
Installing the emulation clips module
•
Installing the iLTA logic timing analyzer option
•
Host installation information
The PICE™ System Instrumentation Chassis Installation
Refer to Figures A -l, A-2, and A-3 when installing the instrumentation chassis. Perform the
following steps for each instrumentation chassis in your PICE system.
1. Unpack the chassis and set it in the desired location.
Provide at least six inches (15 centimeters) of clearance on all sides to ensure proper
cooling.
2. Set the line voltage switch to the appropriate value for your area: 120 for 90-132 VAC
operation or 240 for 180-264 VAC operation. (Use a small screwdriver as a lever.)
Changing the power cord involves hazardous voltages and currents. Only qualified
personnel should change the power cord.
PICE™ SYSTEM NON-HOST
HARDWARE INSTALLATION
1 C A^TIO N ^
WARNING
intel ■ ■
A-l
Advertisement
Table of Contents
