Installing Welding Gun - Miller PipeWorx 400 Owner's Manual

7-23. Installing Welding Gun

Installing gun with
Accu-Mate connection
1
OM-236891 Page 48
4
3
Installing gun without
Accu-Mate connection
2 1
1 Power Clamp Knob
2 Gun Locking Tab
3 Power Pin Groove
4 Gun Connection End
Installing gun with Accu-Mate connection
Loosen power clamp knob to allow power
pin of gun to clear the gun locking tab.
Push power pin into power clamp as far as
possible to align the groove in the power pin
of the gun with the gun locking tab.
Secure gun by tightening power clamp knob.
Installing gun
connection
When using a gun without the groove in the
power pin, loosen power clamp knob and ro-
tate gun locking tab 180 degrees. This pre-
vents the locking tab from extending into the
power pin gun connection.
Push power pin into power clamp as far as
possible.
Secure gun by tightening power clamp knob.
2
245 985-A
without Accu-Mate