Section 3 - Operation; Installing Welding Gun; Installing Gas Supply - Miller INTEGRA 230 Owner's Manual

3-1. Installing Welding Gun

1

3-2. Installing Gas Supply

1
2
SECTION 3 – OPERATION
2
OR
3
4 5
Argon Gas
CO Gas
2
1 Drive Assembly
2 Gun End
Insert gun end through quick con-
nect fitting on front panel, and tight-
en ring nut until it is locked.
Close door.
Ref. ST-802 285-A
Chain gas cylinder to running gear,
wall, or other stationary support so
cylinder cannot fall and break off
valve.
NOTE: All items listed below are
customer supplied.
1 Regulator/Flow Gauge
Install so face is vertical.
2 Gas Hose Connection
Obtain and connect gas hose of
proper size between regulator and
rear of machine.
Note: it may be necessary to install
supplied barbed Euro-adapter, into
gas fitting on rear of machine, be-
fore connecting gas hose.
3 Flow Adjust
Typical flow rate is .57 cmh (cubic
meters per hour). Check wire man-
ufacturer's recommended flow
rate.
4 CO Adapter
2
5 O-Ring
Install adapter with O-ring between
regulator/flow gauge and CO
cylinder.
OM-195 565 Page 7
2