Installing Work Cable And Clamp; Installing Welding Gun - Miller Millermatic 212 Auto-Set Owner's Manual

5-4. Installing Work Cable And Clamp

Tools Needed:
3/4 in.

5-5. Installing Welding Gun

.
A complete Parts List is available at www.MillerWelds.com
2
3
3
1
2
1 Work Cable
2 Boot
Route cable through front panel
opening. Slide boot onto work
cable.
3 Negative (−) Output Terminal
Connect cable to terminal and
cover connection with boot.
1
1 Drive Assembly
2 Gun Securing Knob
3 Gun End
Loosen securing knob. Insert gun
end through opening until it bottoms
against drive assembly (make sure
gun end does not touch drive rolls).
Tighten knob.
4 Gun Trigger Plug
Insert plug into receptacle, and
tighten threaded collar.
Close door.
4
Ref. 804909-B
804913--B
OM-238118 Page 13