Operation Check; Troubleshooting - Korg Nu:Tekt HARMONIC DISTORTION Owner's Manual

3. Attach the rubber feet [4] onto the lower case.
Attach the rubber feet [4] onto the lower case as shown in the
diagram.
4. Attach the volume knobs [3].
Mount the volume knobs onto their spindles.
Tip: The diagram below shows an easy way to position the volume knob
when installing.
Line up the indicator with
the groove on the shaft

Operation Check

When you have successfully finished assembling the unit, test its
operation while reading "Part Names and Functions" on page 8 .
If you have found any problems with assembly or operation, use the
troubleshooting steps below.
Turn the shaft all the way
counterclockwise

Troubleshooting

There aren't enough parts.
• If you have lost some parts, contact us at nutekt.org.
• Also, contact us at nutekt.org if any parts were missing or damaged
before you started to assemble the unit.
I can't assemble the unit, because I broke a part.
• Please contact us at nutekt.org.
The unit makes an abnormal sound when I tilted it or
shook it after assembly.
• A loose screw or other part might be left inside the unit. Open the
lower case and check the inside.
The volume controls or jacks are loose.
• Make sure that the nuts are fastened tightly. Remove the knobs from
the volume controls and retighten the nuts.
• For the footswitch nut, use tool [A].
• For the rear jack nuts, use tool [B].
• For the volume nuts, use tool [C].
- 7 -