Cautions Before Assembly; Assembly - Korg Nu:Tekt HARMONIC DISTORTION Owner's Manual

Cautions Before Assembly

Be careful of injury when handling parts
Use caution not to injure yourself due to the protruding parts when
handling the circuit board. Use cotton work gloves to protect your hands
when working. Also, be sure to wash your hands thoroughly after working.
Tighten screws at a perpendicular angle
Tightening screws that are inserted diagonally may damage the threads,
making it impossible to tighten them again. Be sure to tighten screws so
that they are inserted perpendicular to the surface.
Use caution, as applying too much torque and tightening the screws too
tightly may damage the parts.
Do not injure yourself or scratch the surface with the
tools.
When using tools to tighten screws, make sure not to injure yourself, such
as by getting your fingers pinched. Work carefully to avoid scratching the
case or circuit board with the tools.
Provide a sufficiently large work space to complete the assembly
procedure, and prepare work mats so parts will not be scratched.
Avoid losing the screws
Handle the screws with caution, to avoid losing them. Do not use other
screws aside from the ones included with this kit, and do not use the
screws included with this kit for any other purpose.

Assembly

1. Connect the battery and fit it into the battery space.
Batteries are not included. You will need to purchase a commercially
available 9V alkaline battery (6LF22/6LR61).
Store the battery connector in the battery cushion if you won't be
using the batteries.
2. Close the lower case [2], and secure it with the screws.
Close the lower case and secure it with the case screws [5] in four
places. Use tool [D] for this.
Take care not to pinch the harness or other parts when closing the
case.
- 6 -