Vent Connector - Lennox KG 024 User's Information Manual

HEAT EXCHANGER ASSEMBLY
092-150 UNITS
HEAT
EXCHANGER
TUBE
COMBUSTION
AIR INDUCER
GAS VALVE
BURNER
FIGURE 6
HEAT EXCHANGER ASSEMBLY
180-300S UNITS
HEAT
EXCHANGER
TUBE
COMBUSTION
AIR INDUCER
GAS VALVE
BURNER
FIGURE 7
507350-06 8/2022
Service
To maintain efficiency and longevity, your equipment
must be serviced yearly by a qualified service technician.
Failure to provide proof of service can void warranty.
Label all wires prior to disconnection when servicing
controls. Wiring errors can cause improper and
dangerous operation. Verify proper operation after
servicing.
Servicing Filter
Units are equipped with filters as shown in Table 1. Filters
should be checked monthly and replaced when neces-
sary. Take note of air flow direction marking on filter frame
when reinstalling filters. See Figure 8.
VENT
NOTE - Replace factory-installed filters within 30 days of
CONNECTOR
initial unit start-up. Refer to local codes or appropriate ju-
risdiction for approved filters.
Units are shipped from the factory with temporary filters.
Replace filters before building is occupied. Damage to
unit could result if filters are not replaced with approved
filters. Refer to appropriate codes.
KGA036, 048, 060;
KGB024, 030, 036, 048
KGB060, 074
092, 102, 120, 150
180, 210, 240, 300S
VENT
CONNECTOR
Page 6
CAUTION
WARNING
TABLE 1
UNIT FILTERS
Unit
NOTE - Filters must be ULC approved or equivalent for use in Canada.
REMOVE FILTERS
FIGURE 8
Qty Filter Size - inches (mm)
4 16 X 20 X 2 (406 X 508 X 51)
4 20 X 20 X 2 (508 X 508 X 51)
4 20 X 25 X 2 (508 X 635 X 51)
6 24 X 24 X 2 (610 X 610 X 51)