Table of Contents
Advertisement
6-4 Administration Guide
Launch your terminal emulation software and configure the communications software for the values shown in
the table below. These are the default communication parameters that the Netopia 4753 uses.
Parameter
Terminal type
Data bits
Parity
Stop bits
Speed
Flow Control
Note: The router firmware contains an autobaud detection feature. If you are at any
screen on the serial console, you can change your baud rate and press Return
(HyperTerminal for the PC requires a disconnect). The new baud rate is displayed at
the bottom of the screen.
Suggested Value
PC: ANSI-BBS
Mac: ANSI, VT-100, or VT-200
8
None
1
9600 bits per second (can be set for up to 57600)
None
Advertisement
Table of Contents
