Netopia 3386-ENT Getting Started Manual page 29

Address Translation Enabled:
IP Addressing...
Remote IP Address:
Remote IP Mask:
PPP Authentication...
Send User Name:
Send Password:
PREVIOUS SCREEN
Toggle to Yes if this is a single IP address ISP account.
Enter basic information about your WAN connection with this screen.
Note: The appearance of this screen varies, depending on the settings in the previous screen.
1. To enable address translation, toggle Address Translation Enabled to Yes (the default). For more
information on Network Address Translation, see the Firmware User's Guide chapter on "Multiple Network
Address Translation (MultiNAT)".
2. From the IP Addressing pop-up menu, choose between Unnumbered and Numbered addressing. Unless
otherwise specified by your service provider, accept the default Unnumbered.
If you selected Unnumbered IP Addressing:
•
Select the editable field labeled Remote IP Address and enter the remote IP address. Press Return.
•
Select the editable field labeled Remote IP Mask and enter the remote mask address. Press Return.
If you selected Numbered IP Addressing, the following fields appear:
•
Select the editable field labeled Local WAN IP Address.
The default address is 0.0.0.0, which allows for dynamic addressing, when your ISP assigns an address
using DHCP or PPPoE. However, you can enter another specific address if you want to use static
addressing. In that case, enter the local WAN address your ISP gave you. Press Return.
• Select the editable field labeled Local WAN IP Mask. Enter the subnet mask address your ISP gave
you, or leave 0.0.0.0, when using DHCP or PPPoE. Press Return.
3. Select PPP Authentication and press Return. The authentication protocol and user name/password
combinations you enter must be assigned or agreed to in advance between you and your ISP.
From the pop-up menu that appears, select the authentication method your ISP uses: PAP (Password
Authentication Protocol), CHAP (Challenge Handshake Authentication Protocol), or None.
• PAP is the most common, and requires you to enter a User Name and Password in the next two fields.
• CHAP requires you to enter a Host Name and Secret in the next two fields.
4. Press the Down arrow key until you reach NEXT SCREEN. Press Return to bring up the next screen.
Connection Profile 1: Easy Setup Profile
Yes
Unnumbered
127.0.0.2
255.255.255.255
PAP
NEXT SCREEN
Easy Setup 6-5