Configuring Tcp/Ip On Macintosh Computers - Netopia 3386-ENT Getting Started Manual

4-4 Getting Started Guide
3. Click on the Gateway tab (shown below).
Under "New gateway," enter
192.168.1.1. Click Add. This is the
Netopia 3386-ENT's pre-assigned IP
address.
4. Click OK in this window and the next window. When prompted, reboot the computer.
Note: You can also use these instructions to configure other computers on your network with manual or static
IP addresses. Be sure each computer on your network has its own IP address.
Configuring TCP/IP on Macintosh Computers
The following is a quick guide to configuring TCP/IP for MacOS computers. Configuring TCP/IP in a Macintosh
computer requires the following:
•
You must have either Open Transport or Classic Networking (MacTCP) installed.
If you want to use the Dynamic Host Configuration Protocol (DHCP) server built into your Netopia 3386-ENT
to assign IP addresses to your Macintoshes, you must be running Open Transport, standard in MacOS 8
and higher and optional in earlier system versions.
•
You must have built-in Ethernet or a third-party Ethernet card and its associated drivers installed in your
Macintosh.
Click on the DNS Configuration tab. Click Enable DNS.
Enter the following
information:
Host: Type the name
you want to give to
this computer.
Domain: Type your
domain name. If you
don't have a domain
name, type your ISP's
domain name; for
example,
netopia.com.
DNS Server Search
Order: Type the
primary DNS IP
address given to you
by your ISP. Click
Add. Repeat this process for the secondary DNS.
Domain Suffix Search Order: Enter the same domain
name you entered above.