Table of Contents
Advertisement
®
MAGNUM PRO
CURVE HDE FCAW HYPERFILL
CONNECTOR KIT INSTALLATION TO GUN CABLE
MAGNUM PRO® CURVE HDE FCAW HYPERFILL are
shipped as generic assemblies and must be assembled to a
Magnum Connector Kit before they can be connected to a
wire feeder. See Connector Kit Table on page A-1 for
appropriate connector kit.
K466-6 and K466-10 Installation (Wirematic and
Lincoln 10 Series Feeders)
a)
Remove brass cable connector (see Figure 1) from
the connector kit and screw it onto the fedder end of
the gun cable. Tighten the connection with the
wrench provided.
b) Check that the mo
ga
tting hole in the side of the feeder end handle.
c)
Attach the gun control cable provided to the trigger
connector on the front of the wire feeder.
ROTATING THE GUN TUBE
The gun tube can be rotated to any position desired by the
operator. Loosen the front insert molded guntube piece,
rotate the gun tube to the desired position and retighten the
nut with hands.
CONTACT TIP AND GAS NOZZLE INSTALLATION
a.
Choose the correct size contact tip for the electrode
being used (wire size is stenciled on the side of the
contact tip) and screw it snugly into the gas diffuser.
b.
Be sure the nozzle insulator is fully screwed onto the
gun tube and does not block the gas holes in the diffuser.
c.
Slip the appropriate gas nozzle onto the nozzle
insulator. Adjustable gas nozzles are available with a .62"
(15.9 mm) or
.50" (12.7 mm) I.D., and in both standa
recessed design. The proper nozzle should be selected
based on the welding application. Differen
nozzles are also available to allow either spray or short-
circuiting transfer welding.
Choose the gas nozzle. For the Outershield (FCAW) process,
1/8" (3 mm) recess is recommended.
ng is sealing the
and
ed
A-5
INSTALLATION
Advertisement
Table of Contents
