Extron electronics DSC HD-HD 4K PLUS A Series Setup Manual page 2

DSC HD-HD 4K PLUS A Series • Setup Guide (Continued)
Front Panel Overview
CONFIG
A A B B
Status LED (power and signal)
A
USB Config port
B
Input status LEDs
C
Status LED — This bicolor LED lights amber when the unit is powered on but no signal is present, blinks amber every
A
3 seconds when the unit is in standby mode, and lights green when both power and an input video signal are present.
USB configuration port — Connect a host to this USB mini‑B port for device configuration, control, or firmware updates.
B
C Input LEDs — Light to indicate the following:
• Signal — An input signal is present.
• HDCP — The input signal is encrypted with HDCP.
• Audio — An audio signal (two‑channel LPCM or multi‑channel PCM) is present in the HDMI input.
Output LEDs — Light to indicate the following:
D
• Signal — HDMI video is being output. If the video is muted, this LED does not light.
• HDCP — The output signal is encrypted with HDCP.
• Audio — An audio signal (two‑channel LPCM or multi‑channel PCM) is present in the HDMI output.
Menu and Enter buttons — Let you access the on‑screen display (OSD) and make selections from the submenus.
E
Navigation buttons (right
F
lock the front panel (see the next section), perform Auto‑Image™ (press
Configuring the DSC HD-HD 4K PLUS A Series
The DSC HD‑HD 4K PLUS A series can be configured through a host connected to the RS‑232, USB, or LAN port using Extron
PCS configuration software (available at no charge at www.extron.com), SIS commands (see page 4 for a selection of
commands), or the Web page (see the DSC HD-HD 4K PLUS A Series User Guide, available at www.extron.com). You can also
configure the scaler using the OSD menu system.
OSD Menu System
The on‑screen display (OSD) menu system consists of seven submenus
and one information screen. To access the menus, press the front panel
Menu button. With the main menu displayed, use the arrow buttons to step
through the submenus and submenu items. Press the Enter button to
select highlighted items. The Device Info screen is read‑only and does
not provide selections.
•
Quick Setup
•
Picture Controls
•
Input
•
Output
NOTE:
The OSD times out and closes after 1 minute if no buttons are
pressed.
2
INPUT OUTPUT
SIGNAL
SIGNAL
HDCP
HDCP
AUDIO
AUDIO
C C D D
Output status LEDs
D
Menu and Enter buttons
E
Navigation buttons
F
, left , up , and down
•
Audio
•
Advanced
•
Communication
•
Device Info
DSC HD-HD 4K Plus A xi
MENU
AUTO-
IMAGE
ENTER
HOLD FOR XGA/720p
E E F F
arrow buttons) — Let you navigate through the OSD submenus,
), and reset the output rate (hold for 5 seconds).
basic