NETGEAR FR314 Reference Manual page 136

Reference Guide for the Model FR314, FR318 and FV318 Cable/DSL Firewall and VPN Routers
On the rear panel of the router, locate the small hole to the left of the Normal/Uplink button. A
3.
small pushbutton is accessible through this hole.
With the router powered off, use a thin tool such as a pencil point to press and hold the
4.
pushbutton.
While holding the pushbutton, turn on the router.
5.
Within about 5 seconds, the Test LED begins to blink. Release the pushbutton.
6.
The Test LED will blink for approximately 90 seconds while the software is erased, and it will
then stay on.
When the Test LED stops blinking and stays on, launch your browser and access the Web
7.
Management Interface at http://192.168.0.1.
In the Web Management Interface, click Browse and locate the router software file from your
8.
hard drive.
Click Upload.
9.
Note: When uploading firmware to the firewall router, it is important not to interrupt the Web
browser by closing the window, clicking a link, or loading a new page. If the browser is
interrupted, it may corrupt the firmware. When the upload is complete, your router will
automatically restart.
After the router has rebooted, reconnect your LAN and WAN connections.
10.
This procedure restores the Web Management Interface password to "password" and restores all
configuration settings to factory defaults.
12-8 Troubleshooting