NETGEAR FR314 Reference Manual page 108

Reference Guide for the Model FR314, FR318 and FV318 Cable/DSL Firewall and VPN Routers
From the Edit menu at the top of the Security Policy Editor window, click Add, then Connection.
A "New Connection" listing will appear in the list of policies..
Click and rename the "New Connection" list item to a descriptive name such as "SantaClara"
1.
In the Connection Security box on the right side of the Security Policy Editor window, select
2.
Secure.
In the ID Type menu, select IP Subnet.
3.
In the Subnet field, type the NETGEAR Firewall LAN IP Address of the router to which you
4.
will be connecting.
In the Mask field, type the NETGEAR Firewall LAN Subnet Mask.
5.
In the Protocol menu, Select All to allow all traffic through the VPN tunnel.
6.
Check the Connect using Secure Gateway Tunnel checkbox.
7.
In the ID Type menu below the checkbox, select Domain Name.
8.
Enter the NETGEAR Firewall's Unique Firewall Identifier in the field directly below the ID
9.
Type menu. Note that this field is case sensitive.
Enter the NETGEAR Firewall WAN IP Address in the IP Address field. (If NAT is enabled on
10.
the firewall router, this is the firewall router's NAT Public Address).
10-10 Virtual Private Networking