Table of Contents
Advertisement
Assembly/Set up
STEP 1 BOTTOM & SIDE PANELS
Install three screws from the top and three Hex nuts from below as
shown for each side panel.
Tighten screws.
Panel with hole
must be installed
as shown.
STEP 2 CASTERS
Carefully turn over assembly.
Install Casters by threading them into position as shown.
NOTE: The Casters with locking arms attach to the front of the assembly.
Tank caddy location is on left when assembly is viewed from front.
Locking Arm
Front of Assembly
STEP 3 MIDDLE DIVIDER
Turn over assembly so wheels are down.
Install Middle Divider as shown.
8
(cont.)
6 Required
2 Required
NOTE: The tall side of the
middle divider should be on
the front side of the grill.
STEP 4
TOP PANEL
6 Required
Set Top Panel into position
on top of Middle Divider.
Align holes and hand-
install 2 screws.
Install screws where Top
Panel joins to Sides.
Tighten screws.
STEP 5 BACK PANEL
Install Back Panel as shown.
NOTE: Top & bottom row of screw holes have
weld nuts. No nuts are required for these screws.
Back of Assembly
Tighten ALL screws
previously hand-tightened.
The Cabinet Assembly is
now complete. Only Front
Casters have locks to
secure unit.
6 Required
Front of Assembly
Advertisement
Table of Contents
