Table of Contents
Advertisement
Assembly/Set up
STEP 6 INSTALLING IGNITION BOX
Install the Ignition Box to the left front leg
(on the inside surface) with two self-tapping
screws. Two holes are provided for location.
2 Required
STEP 7 RIGHT SIDE TABLE
Remove preinstalled screws from Right Supports.
Install Right Side Table.
NOTE: Side Table Supports have slots for easy assembly.
Tighten securely.
STEP 8 LEFT SIDE BURNER
Remove preinstalled screws from Left Supports.
Install Left Side Burner Table.
NOTE: Side Table Supports have slots for easy assembly.
Tighten securely.
Front
of unit
Remove hairpin cotter from the post
on the underside of the burner.
Install the Side Burner with the
Burner Venturi pointing toward the
Valve Control Knob location.
(cont.)
Front
of unit
BURNER
VENTURI
STEP 8 LEFT SIDE BURNER
Insert the post through the mounting hole.
Reinstall the hairpin cotter.
STEP 9 BURNER ASSEMBLY
Remove plastic wrap from the HVR (Hose, Valve, Regulator) before lifting
the grill assembly and placing onto the frame.
Remove eight sets of hardware, shown below, from the hardware
package.
NUT
WASHER
8 Required
Install eight (8) spacers by aligning
keyed protrusions into the grill side
and lock in place with 1/2 turn.
Install Grill Assembly as shown.
(Two people required.)
Front of Unit
Both sections of Hose & Tee must pass
through hole in Panel.
Eight (8) Bolts, Washers and Nuts are
required. Install Bolts through Frame,
Spacer and side of the grill. Place
Washer and Nut on Bolt and tighten.
Install at each corner.
(cont.)
POST
SPACER
BOLT
Bolt
Washer
Nut
9
Advertisement
Table of Contents
