Beater To Bowl Clearance - KitchenAid KEC50C Manual

USING THE STAND MIXER

BEATER TO BOWL CLEARANCE

Your Stand Mixer is adjusted at the factory so the flat beater just clears the bottom of the
bowl� If for any reason the flat beater hits the bottom of the bowl or is too far away from
the bowl, you can correct the clearance easily�
Turn speed control to "0"� Unplug
1
Stand Mixer�
Turn beater height adjustment screw
(A) slightly counterclockwise (left) to
raise the flat beater; or turn clockwise
(right) to to lower the flat beater�
3
Adjust so that the flat beater just
clears the surface of the bowl� If you
over adjust the screw, the bowl lift
lever may not lock in place�
NOTE: When properly adjusted, the flat beater will not strike on the bottom or side of
the bowl� If the flat beater or the wire whip is so close that it strikes the bottom of the
bowl, the coating may wear off the flat beater (for coated beaters) or wires on the wire
whip may wear�
Scraping sides of bowl may be necessary under certain conditions regardless of beater
adjustment� The Stand Mixer must be stopped to scrape bowl or damage to Stand
Mixer may occur�
W11330575A.indb 11
2
Lower the bowl to the down position�
USING THE STAND MIXER | 11
3/5/2019 10:50:46 AM