USING THE STAND MIXER
Insert attachment shaft housing into
attachment hub, making certain that
attachment power shaft fits into
square attachment hub socket� It may
3
be necessary to rotate attachment
back and forth� When attachment
is in proper position, the pin on the
attachment will fit into the notch
on the hub rim�
5
Plug into proper electrical outlet�
Loosen attachment knob by
turning it counterclockwise� Rotate
7
attachment slightly back and forth
while pulling it out�
NOTE: See the Use and Care Guide of each specific attachment for recommended
speed settings and operating times�
14 | USING THE STAND MIXER
W11330575A.indb 14
Tighten attachment knob by turning
4
clockwise until attachment is
completely secured to Stand Mixer�
To remove: Turn speed control
6
to "0"� Unplug Stand Mixer�
8
Replace attachment hub cover�
3/5/2019 10:50:47 AM