Operation; Standards - Tripp Lite SmartOnline S3MX Owner's Manual

2. Important Safety Warnings
When installing the unit, verify that any maintenance bypass panel used is configured correctly before applying power to the unit.
• Be sure to place a warning label on all primary power isolators installed remotely from the UPS area and on any external access points
between such isolators and the UPS. The warning label shall carry the following wording or equivalent.

2.8 Operation

Do not disconnect the earth conductor cable on the UPS or the building wiring terminals at any time, as this will cancel the protective
earth of the UPS system.
In order to fully disconnect the UPS system, first press the "OFF" button, then disconnect the mains.
Ensure no liquid or other foreign objects can enter into the UPS system.

2.9 Standards

*Safety
IEC 62040-1: 2008+A1:2013
*EMI
Conducted Emission .....................................EN 62040-2: 2006
Radiated Emission .......................................EN 62040-2: 2006
*EMS
ESD............................................................EN 61000-4-2
RS .............................................................EN 61000-4-3
EFT. ............................................................EN 61000-4-4
SURGE .......................................................EN 61000-4-5
CS .............................................................EN 61000-4-6
Power-Frequency Magnetic Field ....................EN 61000-4-8
Low-Frequency Signals .................................EN 61000-2-2
Warning: This is a product for commercial applications. Installation restrictions or additional precautions may be needed to
prevent disturbances.
Before working on this circuit
- Isolate Uninterruptible Power System (UPS)
- Then check for Hazardous Voltage between all terminals
including the protective earth.
Risk of Voltage Backfeed
6
Category C3
Category C3
Level 4
Level 3
Level 4
Level 4
Level 3
Level 4