Table of Contents
Advertisement
4
Connect the smart device to the USB-C connector (USB-PD compatible).
Connect using the smart device's genuine cable or a USB certified cable. When using a Lightning
cable, use an MFi certified cable.
• It may take a few seconds for the smart device to start charging as it sets the optimal
• If a device exceeding the rated current is connected to the USB-C connector (USB-PD
• Depending on how the smart device is used, it may not be fully charged. (For example,
• To communicate with the printer via Bluetooth while connecting a smart device such as a
• To use the tethering function of the printer, you need to configure the settings according to
• If the printer is connected to a wired network, a smart device connected via USB will be
current value. Charging may also be stopped once immediately after connection.
compatible), charging to the device will stop.
when the screen brightness is at maximum, or when the sleep function (turning off the
screen) is disabled.)
tablet device to the USB-C connector (USB-PD compatible), set [USB-PD Mode] to [Source
Fixed]. See
"Software Settings" on page 65
Also, charging may not be possible depending on the connected smart device, so make
sure to thoroughly check and evaluate the device before use.
the OS of your smart device. See
34
for more details.
able to communicate over the network via USB. See
Tethering Settings" on page 34
("Product Specifications" on page
for setting instructions.
"How to Change the Network Tethering Settings" on page
"How to Change the Network
for more details.
Chapter 1 Product Overview
116)
35
Hide quick links:
Advertisement
Table of Contents
