Switching Your 338 On And Off; To Switch On; To Switch Off; Power Saver - NEC 338 Product Manual

When the battery runs out, the above image blinks and there is an audio alarm. The phone switches off shortly afterwards. If
the low battery alarm occurs during a call, the call will be disconnected after approximately 60 seconds.
The volume level of the low battery alarm depends on the settings of the ringtune volume on standby and the earpiece
volume during a call.

Switching your 338 on and off

To Switch On

After inserting the USIM card (see pages 4 and 5) and the inserting/charging the battery (see pages 6 and 7), press the End
(On-Off) key until the phone switches on (approximately two seconds).

To Switch Off

In Standby mode, press and hold the End (On-Off) key until the phone powers down. There may be some delay while the
phone switches off. Do not attempt to switch the phone on again during this time.

Power Saver

The power saver function turns the screen off when the phone is left idle for a certain period of time. You can turn the screen
back on by pressing any key.

Setting the Clock

When using your 338 for the first time you are prompted to set the current date and time.

To Set the Clock

1
Press the MENU key, select the Settings icon, select Date and time and Set date and time.
2
Enter the current date and time. Refer to Date and time on page 64 for details.
Setting up your 338
Low battery alarm
-8-