Table of Contents
Advertisement
C-24
Explanation:
Prints spaces or line feeds without carriage returns. When n is O s
spaces will be inserted up to a maximum of 127. If n is set to 1 s
line feeds will be performed
Explanation:
This command must be given at the beginning of the line. The
data in the print buffer is lost and the right margin is set to n
columns of the current character width. When the right margin is
reached, a carriage return and line feed is added to the characters
being printed.
(n) (s)(data 1) .
(n) (s)(data 1) .
(n) (s)(data 1) .
(n)
(n)
(n)
Select User-Defined Set
%
37
25
Define User-Defined Characters
<NUL> <NUL> <NUL>
58
0
0
0
3A
00
00
00
<ESC>
27
18
<ESC>
27
18
Copy ROM Into User-Defined Characters
Format:
ASCII code:
Decimal:
Hexadecimal:
ESC%
Explanation:
This code selects the user-defined set if n
=
1 and the normal set
if
n
=
0. ESC
!
and ESC
&
are required to define the character set.
C-25
Format: _,.
ASCII code:
<ESC>
&
<NUL>
(m)
Decimal:
27
38
0
(m)
Hexadecimal:
18
26
00
(m)
Explanation:
This command allows characters to be re-defined in the currently
selected mode. The mode to be used must be selected before down-
loading the character(s). m should be O and n ands should be in the
range of 58 to 63.
Explanation:
This code allows the characters in the GX-80 ROM to be copied
into the user-defined character set so that specific characters can
be redefined. Select the mode to be used ( draft or Near Letter
Quality as required) to ensure the correct set is copied.
ESC&
Format:
ASCII code:
Decimal:
Hexadecimal:
C.10 User-Defined Characters
ESC:
Set Left Margin
Set Right Margin
(s)
(s)
(s)
Horizontal/Vertical Skip
(n)
(n)
(n)
(n)
(n)
(n)
(n)
(n)
(n)
a
81
51
<ESC>
f
27
102
18
66
<ESC>
I
27
108
18
6C
<ESC>
27
18
Format:
ASCII code:
Decimal:
Hexadecimal:
ESC f
Format:
ASCII code:
Decimal:
Hexadecimal:
ESC I
Format:
ASCII code:
Decimal:
Hexadecimal:
Explanation:
The character "l" is a lower case "L" as in "hello". This command
should be placed at the beginning of a line. The data in the print
buffer is lost and the left margin is set to n columns of the current
character width. The value of n should be in the range Oto 160,
but will be ignored
if
the setting would give a margin of more than
8 inches.
ESCQ
Advertisement
Table of Contents
