NEC PG-6200 User Manual page 91

SETTING
Video Mode Selection
This function is used to select the NTSC 3.58, NTSC 4.43, PAL or
SECAM video standard.
To select any one of the video standards, proceed as follows:
1 Press the ADJUST button to display the "ADJUST" menu.
• The projector may ask you to enter your passcode.
See page 52 for the explanation of the PASSCODE.
2 Use the CURSOR
or
line. Press ENTER to display the "OPTION" menu. You can also
select the "OPTION" menu directly by pressing the INPUT "9"
button.
• The eighth item is "8/OPTION" in stand alone adjust menu.
3 Use the CURSOR
or
MODE" line. Press ENTER to display the "SETTING MODE"
menu. You can also select the "SETTING MODE" menu directly
by pressing the INPUT "1" button.
4 Use the CURSOR
or
SELECT" item, then press ENTER to display the "VIDEO
MODE SELECT" menu.
NOTE: The SETTING MODE has three menus. The "VIDEO
MODE SELECT" menu is on the first menu (P01). To access
P02 or P03 from P01, press and hold down the CTL button then
press the button; to return to P01 from P02 or P03, press
and hold down the CTL button then press the
button to highlight the "9/OPTION"
button to highlight the "1/SETTING
button to select the "VIDEO MODE
button.
– A D J U S T –
1 / S I G N A L E N T R Y
2 / F O C U S
3 / A L I G N M E N T
4 / C O N V E R G E N C E
5 / W H I T E B A L
6 / R , G , B G A I N
7 / H O U R M E T E R
8 / P A S S C O D E
9 / O P T I O N
– O P T I O N –
1 / S E T T I N G M O D E
2 / M E N U M O D E
3 / S E Q U E N C E R
4 / P J A D D R E S S
5 / V E R S I O N
P01
CONNECT CONDITION
ASTIG OUTPUT
DEGAUSS
POINT CONVERGENCE
S-VIDEO MODE SELECT
VIDEO MODE SELECT
70
OPTION – SETTING MODE –
STANDALONE
CEILING
FRONT
ENABLE
S2
AUTO