NEC PG-6200 User Manual page 33

SIGNAL ENTRY
When using with two or more ISS-6010/ISS-6010G switchers:
Use the CURSOR or
of the master Switcher and press ENTER. Then select the slot
number of the slave Switcher and press ENTER.
• The "MASTER" menu will be displayed when the slot number
of the master Switcher is selected.
• The "SLAVE" menu will be displayed when the slot number of
the slave Switcher is selected.
• Input slot numbers are from 1 through 10.
• The "NAME INPUT" screen will be displayed when you finish
entering the slot number.
• Go on to Step 2).
2) Input the source name by selecting one character at a time
with the INPUT buttons 1 through 10 and by moving the
cursor with the CURSOR
selection of the characters, press ENTER.
• Up to eight characters can be selected.
• Eight characters are assigned to one INPUT button.
• Whenever the INPUT button is pressed, characters will be
rotated.
For example: A
B
• When pressing the INPUT button while holding down the CTL
button, another group of characters will be rotated.
For example: a
b
• The characters corresponding to these INPUT buttons are as
follows:
INPUT 1 A, B, C, and 1
INPUT 2 D, E, F, and 2
INPUT 3 G, H, I, and 3
INPUT 4 J, K, L, and 4
INPUT 5 M, N, O, and 5
INPUT 6 P, Q, R, and 6
INPUT 7 S, T, U, and 7
INPUT 8 V, W, X, and 8
INPUT 9 Y, Z, ?, and 9
INPUT 10 *, ,, ., and 0
• If you have made an error in the input of a character, use the
CURSOR button and enter the correct letter or number.
To delete one character, move the CURSOR
character to be deleted and then press the NORMAL button.
To delete all the entered name, hold down the CTL button then
press NORMAL.
• The "INITIAL DATA SELECT" menu will be displayed.
button to select the input slot number
button. After finishing the
C 1 A .....
c ! a .....
When using With CTL
a, b, c, and !
d, e, f, and "
g, h, i, and #
j, k, l, and $
m, n, o, and %
p, q, r, and &
s, t, u, and '
v, w, x, and (
y, z, /, and )
;, :, +, and -
button to the
M A S T E R
S L O T – 0 1
S L O T – 0 2
S L O T – 0 3
S L O T – 0 4
S L O T – 0 5
S L O T – 0 6
S L O T – 0 7
S L O T – 0 8
S L O T – 0 9
S L O T – 1 0
18
S L A V E
S L O T – 0 1
S L O T – 0 2
S L O T – 0 3
S L O T – 0 4
S L O T – 0 5
S L O T – 0 6
S L O T – 0 7
S L O T – 0 8
S L O T – 0 9
S L O T – 1 0
N A M E I N P U T
– – – – – – – –