NEC PG-6200 User Manual page 54

BASIC OPERATION
NOTE:
• While you are viewing a source screen, you can also select
the input signal directly by pressing the INPUT "1"
through "10" button. In this case INPUT buttons function
as follows:
When using the projector in stand alone operation:
INPUT 1 Selects the VIDEO input on the projector
INPUT 2 Selects the RGB input on the projector
INPUT 3 Selects the S-VIDEO input on the projector
When using the projector with the ISS-6010/ISS-6010G:
INPUT 1 through 10
When using the projector with two ISS-6010/ISS-6010G or more:
To switch to another input signal, enter the master slot
number, then the slave slot number by using INPUT
buttons and press ENTER.
For example:If you want to select a signal from the no.3 slot of
the slave Switcher which is connected to the no.2 slot of the
master Switcher, first press the INPUT "2" button, then the
INPUT "3" button and finally press ENTER.
INPUT SELECT List Format
The Switcher connected
Slot number of the master
Switcher
Slot number of the slave
Switcher
Selects the corresponding number
slot of the ISS-6010/ISS-6010G
Page (P01 to P10)
P01 INPUT SELECT
ISS-6010
NO INPUT
0 1 M – 01
0 2 M – 01
0 3 M – 01
0 4 M – 01
0 5 M – 01
0 6 M – 01
0 7 M – 01
0 8 M – 01
0 9 M – 01
1 0 M – 01
• You can switch to any input signal of NO 01 through10 on
the INPUT SELECT list by holding down the CTL button
and pressing one of the INPUT buttons corresponding to
the input number. Prior to this, you are required to select
ENABLE in the DIRECT ENTRY ACCESS mode. For further
details, contact your dealer.
• When pressing any one of the INPUT buttons to directly
access one signal among two or more of the same signals,
the projector will output the signal listed in the upper line
automatically. To select the one listed in the lower line, use
the CURSOR
Connection condition of the Switcher
SW 2 LEVEL
NAME
S – 01 V T R – 1
S – 02 V T R – 2
S – 03 V I D E O - 1
S – 04 V T R – 3
S – 05 R G B - 1
S – 06 V I D E O - 2
S – 07 V I D E O - 3
S – 08 N T S C
S – 09 P A L
S – 10 S E C A M
24
or button and press ENTER.
DATE
12 / 01 / 90
12 / 03 / 90
12 / 11 / 90
12 / 24 / 90
12 / 25 / 90
12 / 30 / 90
Date registered
12 / 31 / 90
01 / 15 / 91
01 / 16 / 91
01 / 29 / 91
Source name of input signal