Assembly - Delta 50-850 Instruction Manual

UNPACKING AND CLEANING
Carefully unpack the machine and all loose items from the shipping container(s). Remove the rust-preventative oil from
unpainted surfaces using a soft cloth moistened with mineral spirits, paint thinner or denatured alcohol.
Do not use highly volatile solvents such as gasoline, naphtha, acetone or lacquer thinner for cleaning your
machine.
After cleaning, cover the unpainted surfaces with a good quality household floor paste wax.
For your own safety, do not connect the machine to the power source until the machine is
completely assembled and you read and understand the entire instruction manual.
ASSEMBLY TOOLS REQUIRED
Phillips head screwdriver (not supplied)
3/8", 1/2", and 9/16" open-end wrenches (not supplied)
ASSEMBLY TIME ESTIMATE
30 minutes to 1 hour
This machine is heavy. Use two or more people when lifting.
CASTERS TO BASE
Disconnect the machine from the power source!
1. Insert threaded rod of caster (A) Fig. 3, into the hole
located on the underside of base (B) and fasten with
3/8" lockwasher (C) and 3/8-16 hex nut (D). Fig. 4,
illustrates the caster fastened to the base.
2. Assemble the remaining three casters to the
underside of the base in the same manner.
ASSEMBLING BLOWER AND MOTOR
ASSEMBLY TO BASE
Disconnect the machine from the
power source!
1. Turn base (A) Fig. 5, right side up. Align the mounting
holes at the base of blower and motor assembly (B)
Fig. 5, with six pre-drilled holes (C) in base (A) and
fasten with six 5/16-18 x 5/8" hex head screws (D)
and 5/16" lockwashers (E).
2. Fig. 6, illustrates the blower and motor assembly (B)
fastened to base (A).
Fig. 5
A
C

ASSEMBLY

B
D
E
8 -
English
Fig. 3
A
Fig. 4
Fig. 6
B
A
B
C
D