Panasonic Lumix DMC-FX700P Service Manual page 47

Service Manual
Diagrams and Replacement
Parts List
Digital Camera
Model No.
DMC-FX700P DMC-FX700GC
DMC-FX700PC DMC-FX700GD
DMC-FX700PU DMC-FX700GH
DMC-FX700EB DMC-FX700GK
DMC-FX700EE DMC-FX700GN
DMC-FX700EF DMC-FX700GT
DMC-FX700EG DMC-FX700SG
DMC-FX700EP
Vol. 1
Colour
(S)...........Silver Type (only P/PC/GC/GH/GK/SG)
(K)...........Black Type
(N)...........Gold Type (only GC/GD/GK/GT/SG)
(W)..........White Type (only GC/GD/GH/GT/SG)
Table of contents
S1. About Indication of The Schematic Diagram ............................ S-1
S1.1. Important Safety Notice......................................................... S-1
S2. Voltage Chart ........................................................................... S-2
S2.1. Sub Operation Flex P.C.B. .................................................... S-2
S2.2. Flash Top P.C.B. .................................................................... S-2
S3. Block Diagram .......................................................................... S-3
S3.1. Overall Block Diagram .......................................................... S-3
S4. Schematic Diagram .................................................................. S-4
S4.1. Interconnection Diagram ....................................................... S-4
S4.2. Sub Operation Schematic Diagram....................................... S-5
S4.3. Flash Top Schematic Diagram .............................................. S-6
S4.4. Lens Flex Schematic Diagram .............................................. S-7
S5. Print Circuit Board .................................................................... S-8
S5.1. Sub Operation Flex P.C.B. .................................................... S-8
S5.2. Flash Top P.C.B. .................................................................. S-10
S5.3. Lens Flex P.C.B. .................................................................. S-14
DSC1008051CE
S1. About Indication of The Schematic Diagram
S1.1. Important Safety Notice
COMPONENTS IDENTIFIED WITH THE MARK
FOR SAFETY. WHEN REPLACING ANY OF THESE COMPONENTS USE ONLY THE SAME TYPE.
1.Although reference number of the parts is indicated on the P.C.B. drawing and/or
schematic diagrams, it is NOT mounted on the P.C.B. when it is displayed with "$" mark.
2.It is only the "Test Round" and no terminal (Pin) is available on the P.C.B.
when the TP (Test Point) indicated as "
3.The voltage being indicated on the schematic diagram is measured in
"Standard-Playback" mode when there is no specify mode is mentioned.
4.Although the voltage and waveform available on here is measured with standard frame,
it may be differ from actual measurement due to modification of circuit and so on.
5.The voltage being indicated here may be include observational-error (deviation) due to
internal-resistance and/or reactance of equipment. Therefore, handle the value
indicated on here as reference.
6.Use the parts number indicated on the Replacement Parts List .
7.Indication on Schematic diagrams:
S6. Replacement Parts List .......................................................... S-15
S7. Exploded View ....................................................................... S-20
S7.1. Frame and Casing Section.................................................. S-20
S7.2. Packing Parts and Accessories Section (1) ........................ S-21
S7.3. Packing Parts and Accessories Section (2) ........................ S-22
S-1
" mark.
Circuit name being connected.
This signal is connected
OFTR FEP
to the FEP schematic diagram.
Name of Signal
HAVE THE SPECIAL CHARACTERISTICS