5: Specifying The Speaker Parameters - Sony DHC-FLX9W Operating Instructions Manual

Display side hi-fi component system
Table of Contents

Advertisement

5: Specifying the speaker
parameters
Use the remote for the operation.
1
From your listening position, press
AMP MENU.
Adjustable menus and parameters are
described below.
2
Press V or v repeatedly until "LEVEL
MENU" appears.
3
Press ENTER.
4
Press V or v repeatedly to select the
parameter.
5
Press B or b repeatedly to select the
setting you want.
6
Repeat steps 4 to 5 to set other
parameters.
7
Press ENTER.
Tips
• You can use the digipad instead of the cursor buttons
(V/v/B/b).
• You can use "SPEAKER SETUP" in the Setup
Display to specify the balance, level, and test tone
parameters (page 36).
Adjustable parameters
The default settings are in the parentheses.
x BALANCE
• FRNT L___R: (center)
Balance between the front left and right
speakers.
• REAR L___R: (center)
Balance between the rear left and right
speakers.
Range: 6 steps to the left and 6 steps to the right
(13 steps)
x LEVEL
• REAR: (0 dB)
Level of the rear speakers (–6 dB to +6 dB,
1 dB steps).
• CENTER: (0 dB)
Level of the center speaker (–6 dB to +6 dB,
1 dB steps).
• SUB W.: (+2 dB)
Level of the sub woofer (–6 dB to +6 dB, 1 dB
steps).
x D.COMP.
• D.COMP.: (OFF)
Dynamic range compression.
Range: OFF, 0.1 to 0.9, STD, MAX
"OFF" does not compress the dynamic range.
"0.1" to "0.9" settings allow you to compress
the dynamic range in small steps. "STD"
reproduces the sound track with the dynamic
range intended by the recording engineer.
"MAX" provides a great compression of the
dynamic range.
x TEST TONE
• TEST TONE: (OFF)
Test tone output.
Range: OFF, ON
"ON" outputs the test tone from each speaker
in sequence. Adjust the LEVEL and
BALANCE parameters so that the volume
level of the test tone from each speaker
sounds the same using the remote from your
listening position. Select "OFF" to turn off the
test tone.
Notes
• When 2.1CH/MULTI is set to "2.1CH" (page 60),
you cannot set rear speaker balance, center level, rear
level.
• Dynamic range compression is possible with Dolby
Digital sources only.
GB
21

Advertisement

Table of Contents
loading

Table of Contents