Siemens SITRANS LG270 Operating Instructions Manual page 33

Measurement loop name
Units
Units (2)
Probe length
PBD-51041506
•
The display and adjustment module (address setting via software)
•
PACTware/DTM (address setting via software)
Hardware addressing
Hardware addressing is effective if an address less than 126 is set
with the address selection switches on the electronics module of
SITRANS LG270. In such case, software addressing has no effect -
only the set hardware address applies.
Software addressing
Software addressing is only effective if address 126 or higher is set
on the instrument with the address selection switches.
Here you can assign a suitable measurement loop name. Push the
"OK" key to start the editing. With the "+" key you change the sign and
with the "->" key you jump to the next position.
You can enter names with max. 19 characters. The character set
comprises:
•
Capital letters from A ... Z
•
Numbers from 0 ... 9
•
Special characters + - / _ blanks
In this menu item you select the distance unit and the temperature
unit.
For the distance units you can choose between m, mm and ft and for
the temperature units °C, °F and K.
In this menu item, you select the unit of the Secondary Value (SV2).
It can be selected from the distance units such as for example m, mm
and ft.
In this menu item you can enter the probe length or have the length
determined automatically by the sensor system.
SITRANS LG270 - Operating Instructions
33