Adjusting The Blade - Master MT Pocket Use & Maintenance Manual

Finally, replace the protection grid and fasten it with the help of the three latches.
10

Adjusting the blade

Cutting effectiveness may be lost over time due to an increased distance between the blade and the grid. Below, we
describe how to solve this problem, adjusting the distance between the blade and the grid to make them completely
level. To carry out this operation, the machine must be clean. Protective gloves must be worn during the adjustment
process.
First, press the ON/OFF switch on the machine to turn it off and disconnect it from the power supply. IMPORTANT: The machine must
1
be stopped and disconnected before handling it in any way.
Then check with a calliper or other measuring instrument if the distance between the grid and the blade is greater than 2 mm. In that
2
case, you must adjust the blade to 2 mm to increase cutting efficiency.
Open the three latches on the grid and remove it to gain
3
access to the blade.
30
www.masterproducts.es
2 mm