Master MT Pocket Use & Maintenance Manual page 29

Replace the protection grid and secure it with the help of the three latches. Screw in or unscrew the threaded studs to level the blade as
7
required.
Measure the distance between the two ends of the blade and the grid with a caliper or other measuring instrument as shown in the following
image.
IMPORTANT: If the distance is not the same, it will be necessary to adjust the position, screwing or unscrewing the threaded studs,
as appropriate.
Once the blade is level, remove the grid and secure the two side
8
bolts on both sides with the help of fixed spanner Nº 10, as
shown in the ollowing image.
=
=
Next, tighten the four nuts shown in the following image, using
9
Allen key Nº 3 and fixed spanner Nº 10.
www.masterproducts.es
29