Advertisement
Optional Relay Wiring
Parking Light (Dual Relay, European Vehicles Only)
IN4001 Diode
86
White Wire
IN4001 Diode
86
Horn Output (Relay is Existing
in Vehicle or Newly Installed)
Brown Wire
Channel 3
87
Green Wire
87A
86
30
Programming
A. TRANSMITTERS
A maximum of 4 transmitters can be programmed to function with
this unit. There are two modes of programming. One is Designated
Channel, (Button 1 is door lock/unlock), the other is the Auto
Channel. (Button 1 is door lock, Button 2 is door unlock).
1. Turn Ignition the "On" Position.
Push valet switch 3 times to enter the Designated Channel, or
push valet switch 6 times to enter the Auto Channel. You will
hear one long chirp and one short chirp for the Designated
Channel, or two long chirps and one short chirp for the Auto
Channel.
2. Program Transmitters:
Press any button on first transmitter. One short chirp will con-
firm that it is programmed. Press any button on second trans-
mitter. Two short chirps will confirm that it is programmed.
Apply the same procedure to program a third and fourth trans-
mitter. Three and four chirps respectively will confirm that the
transmitters are programmed.
Left
87
87A
85
30
+12V DC
Right
87
87A
85
30
+12V DC
+
Horn
87
87A
+12V Battery
85
86
30
+12V or Ground
Depending on
System Requirements
+12V DC
85
Electric Device
Starter Disable
Orange Wire
OFF
ON
Start
ACC
Channel 2 (Trunk Release)
87
Gray Wire
87A
86
30
Dome Light
87
Violet Wire
87A
86
30
3. Exit:
Turn the ignition to the "Off" position, or leave it for 10 sec-
onds. Three long chirps to confirm exit.
Note: If more than 4 transmitters are programmed with this
unit, only the last 4 transmitters programmed will function with
this unit.
B. PROGRAMMING SYSTEMS FEATURES
The M2 has 6 features that are programmable. To program these
features, repeat the following procedures.
1. Turn the ignition key "On" then "Off". Within 10 seconds, press
the valet switch 6 times. The horn will sound one long beep to
confirm you are in the feature programming mode.
2. Select the feature you want to program by pressing the valet
switch the number of times indicated in the "Feature Number"
of the chart enclosed. The horn will beep the same number of
times you pressed the valet switch to confirm your selection.
Note 1: If the optional LED indicator has been installed, it will
IN4001
Diode
40A High Current
87
Relay
87A
85
86
30
Starter
Cut
Trunk Release
Switch
+12V DC
85
Trunk Release
Door Switch
+12V DC
85
Courtesy Light
Solenoid
Advertisement
