Cgam100, Cgam110, And Cgam120 Chillers (W2 Units) - Trane CGAM020 Installation Instructions Manual

Installation
CGAM100, CGAM110, and
CGAM120 Chillers (W2 Units)
Table 26. Kit contents FMF14464
# Qty Per Component Part Component Description
1 8 571272480100
2 24 X32030872010
3 40 X25020604010
4 2 572024130100
5 8 572055580100
6 1 572018650100
7 2 572055570100
Table 27. Kit contents LVR01106
# Qty Per Component Part Component Description
1 8 571272480100
2 24 X32030872010
3 40 X25020604010
4 2 572024130100
5 8 572055580100
6 1 572018650100
7 1 572229070100
8 1 572229090100
Table 28. Kit contents LVR01105
# Qty Per Component Part Component Description
1 8 571272480100
2 24 X32030872010
3 24 X25020604010
4 2 572055550100
Figure 17. CGAM100–120 ton (W2 units); 1 of 1
Note: Do not use an impact gun when installing plastic
louvers.
22
PANEL; LVRD UPPER PLASTIC
CLIP-SPEED; S Type Spring
SCREW;M8 X 1.25MM X 16MM
ANGLE; LOUVER
LOUVER; LOWER SIDE CGAM
ANGLE; LOUVER
LOUVER; LOWER END CGAM
PANEL; LVRD UPPER PLASTIC
CLIP-SPEED; S Type Spring
SCREW;M8 X 1.25MM X 16MM
ANGLE; LOUVER
LOUVER; LOWER SIDE CGAM
ANGLE; LOUVER
PANEL; LOUVER W
PANEL; LOUVER, W w/PMP
PANEL; LVRD UPPER PLASTIC
CLIP-SPEED; S Type Spring
SCREW;M8 X 1.25MM X 16MM
LOUVER; UPPER SIDE CGAM
1. Install three clips (Figure 18, p.
louver.
2. Install eight upper louvers
each side, with provided M8 X 16 screws
Item 3).
Note: If installing the half louver option, the
installation is complete at this point.
3. Install two louver support angles
one each side of unit, with provided M8 X 16 screws
(Figure 18, Item 3).
4. Install eight lower louvers
side, with provided M8 X 16 screws
5. Install rear louver angle
provided M8 X 16 screws
6. Install lower end louvers
with provided M8 X 16 screws
23, Item 2) per upper
(Figure 18, Item 1), four
(Figure 18,
(Figure 18, Item 4),
(Figure 18, Item 5), four each
(Figure 18, Item 3).
(Figure 18, Item 6) with
(Figure 18, Item 3).
(Figure 18, Item 7 and Item 8)
(Figure 18, Item 3).
PART-SVN228B-EN