Trane CGAM020 Installation Instructions Manual page 18

Installation
Figure 13. CGAM060–070 ton (V2 units); 2 of 2
1. Install four center louver supports,
Item 1), two to each side of unit, with provided M8 X 16
screws (Figure 14, Item 2).
Note: Do not use an impact gun when installing
plastic louvers.
2. Install eight upper louvers
each side, with provided M8 X 16 screws
Item 2).
3. Install lower end louver support
with provided M8 X 16 screws
4. Install lower end louver post
provided M8 X 16 screws
5. Install lower end louvers
provided M8 X 16 screws
6. Install top control panel strip
provided M8 X 16 screws
7. Install lower support (Figure
with provided M8 X 16 screws
Note: Installation of Item 9 in
on units that do NOT have heat recovery option.
8. Install center rear end support panel
with provided M8 X 16 screws
9. Install the three lower unit end panels
Item 10, Item 11, and Item 12) with provided M8 X 16
screws (Figure 14, Item 2).
10. Install upper unit end panels
Item 14) with provided M8 X 16 screws
Item 2).
11. Install eight lower louvers
side, with provided M8 X 16 screws
18
(Figure 14, p. 19,
(Figure 14, Item 3), four
(Figure 14,
(Figure 14, Item 4)
(Figure 14, Item 2).
(Figure 14, Item 5) with
(Figure 14, Item 2).
(Figure 14, Item 6) with
(Figure 14, Item 2).
(Figure 14, Item 7) with
(Figure 14, Item 2).
14, Item 8) on end of unit
(Figure 14, Item 2).
Step 8 is only required
(Figure 14, Item 9)
(Figure 14, Item 2).
(Figure 14,
(Figure 14, Item 13 and
(Figure 14,
(Figure 14, Item 3), four each
(Figure 14, Item 2).
PART-SVN228B-EN