Advertisement
7. Remove the cover retaining screw and remove the cover from the SECONDARY power center,
located on the top bank, far right side.
8. Route the communication cable from the CPC203 power center through the bottom hole of the
CPC103 Secondary power center.
9. Insert the two wires from the CPC203 into terminal block in same order as the wires already
connected. Be sure to match the wire colors. GREEN to GREEN and YELLOW to YELLOW.
10. Replace the cover on the upper Secondary power center (top far right side). Secure the cover with
the retaining screw.
Communication
wires
PRIMARY
SECONDARY
SECONDARY
GREEN and
YELLOW wire
from CPC203
power center
IntelliChlor Electronic Chlorine Generator COMSYS-12 Installation Guide
Insert wires from
CPC203 into hole and
connect into terminal
connector
CPC103
Terminal screw
connector: Match wires
GREEN to GREEN and
YELLOW to YELLOW
(See step 9)
CPC103
5
Advertisement
