Advertisement
•
If the communication is not established and stable, use the
external resistors provided in the hardware kit.
Enrollment
Figure 5: Enrollment
Follow the below instructions for correct finger swiping starting
from the first finger joint, place the selected finger on the swipe
sensor and move it evenly towards oneself in one steady
movement.
Result:
For a valid swipe: Tricolour Status LED turns green + OK
beep(short +long beep)
For an invalid or misread swipe: Tricolour Status LED turns red
+ error beep ( 3 short beeps)
Configuring the biometric readers in
ACL800 BioManager
ACL800 BioManager is software for fingerprint management of
biometric readers, when used with third party access
controllers.
Main functions:
o
Fingerprint enrollment
It can be done by ANY biometric reader in the network or by
desktop (USB) biometric reader
o
Fingerprint transfer
Finger templates can be sent to any reader in the network.
Different users can be sent to different biometric readers
o
Wiegand output Configuration
The Wiegand output of the biometric reader can be customized
bitwise
Add Portal
•
Right-click on "Portals" and select "Add Portal".
•
If the converter used for the biometric readers is RS485 to
TCP/IP, then create a portal by adding the IP Address of the
converter. (Figure 5)
Figure 6: Add Portal
P/N 1073503A• REV 01.01 • ISS 11SEP18
Note: The portal can be added automatically with the "Search"
function.
Add Reader
•
Right-click on the portal connected to the reader and
select "Add Reader"
•
Select the type of the reader and fill the reader form. Put
the serial number of the biometric reader. The serial number is
written on the back side of the reader, but also can be
searched from the software
Click on "Save" and the reader icon appears under
the selected portal
Right-click on reader and select "Check version" to
see if the reader is online
3 / 7
Advertisement
